Wall Buddies Metal Slide-In
S-HWR-M-2200
About the product
Wall buddies are self-leveling sawtooth hangers that come in pairs, unlike traditional sawtooth hangers. The hangers strengthen the upper corners of frames like corner braces and eliminate the possibility of broken wires and bowed frames, while their sawtooth edges allow frames to be level and flush with the wall.
-
Wall buddies metal frame hangers for metal frames with a #11 profile and at least 11" wide
-
Supports up to 30 lbs
-
Includes two (2) nails and hooks
-
Slide-in wall buddies hangers for metal sectional frames require partial disassembly of a frame
Instructions
-
Place the frame face-down on a blanket or soft surface.
-
Carefully remove the metal springs under the top rail and set these aside, if applicable.
-
Loosen the set screws on the steel corner plates at the upper corners of the frame and remove the top rail by gently pulling it back from the rest of the frame. Take care not to let the side rails splay out when removing the top rail.
-
Remove the steel corner plate and backplate from each end of the top rail.
-
Insert the left and right Wall Buddies Hangers into the top rail channel and replace only the tapped corner plates on top of the hangers. Discard the two backplates.
-
Reassemble the top rail onto the rest of the frame. Be careful not to damage glass or allow debris to enter the frame. Retighten the set screws on the tapped corner plates.
-
Reinstall the metal springs under the top rail.
-
Measure the distance between the arrow marks on the left and right metal slide in wall buddies.
-
Space the two special wall hooks for wall buddies at this distance as level as possible and nail them into the wall. The wall hook nails should be located on the wall approximately 1 1/2" down from where you want the top of the frame to be.
-
Hang the frame so that the sawtooth edges of each Wall Buddies Hanger rests on the exposed shank of the nail inside the special wall hooks.
-
To level the frame, slide it left or right with a slight lifting motion.
Related Content
Everything You Need to Know About Metal Frame Picture Hangers
Dos and Don'ts When Using Metal Frame Hangers
Frequently Asked Questions
Q How do I install metal frame hangers and what tools or hardware do I need?
Most metal frame hangers snap, slide, or clip into the open channel of a standard Nielsen #11 profile metal frame—no tools required. Some designs are wire-compatible, allowing you to string picture wire between two hangers. For heavyweight metal frames, our French cleat kits include all hardware for installation. For a detailed guide, check our article: Do's and Don'ts When Using Metal Frame Hangers.
Q Can I remove metal frame hangers without damaging my walls?
Yes. Metal frame hangers attach to the frame's channel, not to the wall, so removing or swapping them causes no wall damage. Simply unclip or slide the hanger out of the channel.
Q How much weight can metal frame hangers safely hold?
Weight capacity depends on the hanger design and whether it's used with wire or as a direct-hang solution. Our metal frame hangers range from lightweight snap-in options to heavy-duty French cleat kits for large metal frames. Check each product listing for the specific weight rating.
Q What metal frame profiles are these hangers compatible with?
Our metal frame hangers are designed for the industry-standard Nielsen #11 profile, which has a 3/8-inch channel opening. This is the most common metal frame profile used by framers and manufacturers. Check the product listing to confirm compatibility with your frame.
Q What kinds of frames or decor work best with metal frame hangers?
Metal frame hangers are specifically designed for aluminum and metal picture frames with an open channel. They work well for framed prints, posters, photos, and certificates in standard metal frames. For wooden frames, see our wood frame hangers and D-ring collections.